Configuring The Dns Test; Establishing The Configuration Task - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l
l
l
<Quidway> display nqa results
NQA entry(admin, http) :testflag is inactive ,testtype is http
1 . Test 1 result

6.9 Configuring the DNS Test

This section describes how to configure a Domain Name System (DNS) test to check the DNS
resolution speed.

6.9.1 Establishing the Configuration Task

Before configuring a DNS test, familiarize yourself with the applicable environment, complete
the pre-configuration tasks, and obtain the required data. This can help you complete the
configuration task quickly and accurately.
Applicable Environment
The DNS test is performed to obtain the speed at which the specified domain name is resolved
to an IP address.
Pre-configuration Tasks
Before configuring the DNS test, complete the following tasks:
l
l
Data Preparation
To configure the DNS test, you need the following data.
No.
1
2
Issue 01 (2011-10-26)
"DNSRTT"
"TCPConnectRTT"
"TransactionRTT and RTT"
The test is finished
SendProbe:3
Completion:success
MessageBodyOctetsSum: 411
DNSQueryError number: 0
TcpConnError number : 0
DNSRTT Sum/Min/Max:0/0/0
TransactionRTT Sum/Min/Max: 3/1/1
RTT Sum/Min/Max/Avg: 7/1/5/2
DNSServerTimeout:0 TCPConnectTimeout:0
Lost packet ratio:0%
Configuring the DNS server
Configuring routes between the NQA client and the DNS server
Data
Administrator name and test name
IP address of the DNS server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:3
RTD OverThresholdsnumber: 0
TargetAddress: 100.2.1.200
HTTPError number: 0
System busy operation number:0
TCPConnectRTT Sum/Min/Max: 6/1/4
TransactionTimeout: 0
6 NQA Configuration
272