Configuration Examples; Example For Configuring The Icmp Test - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Context
Debugging affects the performance of the system. So, after debugging, run the undo debugging
all command to disable it immediately.
Procedure
Step 1 Run the debugging nqa all command in the NQA view to enable NQA debugging.
----End

6.27 Configuration Examples

This section provides several configuration examples of NQA.

6.27.1 Example for Configuring the ICMP Test

Networking Requirements
As shown in
VLANIF interface.
Switch A functions as the NQA client to check whether Switch B is reachable.
Figure 6-3 Networking diagram for configuring the ICMP test
NQA agent
Configuration Roadmap
The configuration roadmap is as follows:
1.
Data Preparation
To complete the configuration, you need the following data:
l
Issue 01 (2011-10-26)
CAUTION
Figure 6-3, Switch A and Switch B must be connected at Layer 3 through the
SwitchA
GE0/0/1
VLANIF10
10.1.1.1/24
Perform the NQA ICMP test to check whether the route between the local end (Switch A)
and the specified destination end (Switch B) is reachable and check the RTT of a test packet.
Host address of Switch B
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE0/0/1
VLANIF10
10.1.1.2/24
6 NQA Configuration
334