Configuring The Jitter Client - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
The system view is displayed.
Step 2 Run:
nqa-server udpecho [ vpn-instance vpn-instance-name ] ip-address port-number
The UDP monitoring service is configured.
Note that the IP address and port number monitored by the Jitter server should be consistent
with those configured on the client.
----End

6.14.3 Configuring the Jitter Client

This part describes how to configure the client of the jitter test.
Context
Do as follows on the NQA client (Jitter client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 (Optional) To configure the version number of Jitter packets, run the nqa-jitter tag-version
version-number command in the system view.
If Version 2 is adopted, after collecting the packet loss across a uni-directional link is enabled,
you can find the packet loss across the link from the source to the destination (or from the
destination to the source or from an unknown direction). According to these statistics, the
network administrator can easily detect network faults and malicious attacks.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type jitter
The test type is set to Jitter.
Step 5 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 6 Run:
destination-port port-number
Issue 01 (2011-10-26)
NOTE
Only S5700EI and S5700HI support the vpn-instance vpn-instance-name.
NOTE
The system supports the collection of the statistics about the maximum uni-directional transmission delay.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
289