Configuring The Pwe3 Ping Test To Check The One-Hop Pw; Establishing The Configuration Task - Huawei Quidway S5700 Series Configuration Manual - Network Management

Hide thumbs Also See for Quidway S5700 Series:
Table of Contents

Advertisement

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
6.19 Configuring the PWE3 Ping Test to Check the One-Hop
PW
This section describes how to configure a PWE3 ping test to check the connectivity of a single-
hop pseudo-wire (PW).

6.19.1 Establishing the Configuration Task

Before configuring a PWE3 ping test for a single-hop PW, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
To check the connectivity of the one-hop pseudo wire (PW) using LDP as the signaling protocol,
you can perform the PWE3 Ping test on the one-hop PW.
Pre-configuration Tasks
Before configuring the PWE3 Ping test on a one-hop PW, you must correctly configure the
dynamic one-hop PW.
Data Preparation
To configure the PWE3 Ping test on a one-hop PW, you need the following data.
No.
1
2
3
Issue 01 (2011-10-26)
System busy operation number:0
Min Positive SD:1
Max Positive SD:138
Positive SD Number:7
Positive SD Sum:152
Positive SD Square Sum :19116
Min Negative SD:1
Max Negative SD:21
Negative SD Number:14
Negative SD Sum:152
Negative SD Square Sum :2796
Min Delay SD:1
Max Delay SD:72
Delay SD Square Sum:15111
Packet Loss SD:0
Packet Loss Unknown:0
Average of Jitter SD:14
jitter out value:4.7604818
NumberOfOWD:60
OWD SD Sum:339
ICPIF value: 0
TimeStamp unit: ms
Data
ID of the PW
Type of the PW
Type and number of the interface connected with the CE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Operation timeout number:0
Min Positive DS:1
Max Positive DS:3
Positive DS Number:19
Positive DS Sum:21
Positive DS Square Sum :27
Min Negative DS:1
Max Negative DS:4
Negative DS Number:19
Negative DS Sum:22
Negative DS Square Sum :34
Min Delay DS:0
Max Delay DS:71
Delay DS Square Sum:14728
Packet Loss DS:0
Average of Jitter:5
Average of Jitter DS:1
jitter in value:0.5399519
Packet Loss Ratio: 0%
OWD DS Sum:310
MOS-CQ value: 0
6 NQA Configuration
306

Advertisement

Table of Contents
loading

Table of Contents