Huawei Quidway S5700 Series Configuration Manual - Network Management page 278
Hide thumbs
Also See for Quidway S5700 Series:
- Hardware description (253 pages) ,
- Configuring and troubleshooting (19 pages) ,
- Hardware installation and maintenance manual (183 pages)
Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the FTP upload
test ( For detailed parameter configurations, see the chapter
Parameters
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source port, run the source-port port-numbercommand.
l To configure the destination port, run the destination-port port-number command.
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
ftp-operation put
The FTP operation type is set to Put.
By default, the FTP operation type is Get.
Step 7 Run:
ftp-username name
The FTP user name is configured.
Step 8 Run:
ftp-password password
The FTP password used during the login is configured.
Step 9 Perform the following as required to upload the file.
l To upload the file with a specified name, run the ftp-filename file-name command.
l To upload the file with a specified size, run the ftp-filesize size command. The client then
Step 10 Run:
start
Issue 01 (2011-10-26)
):
command.
NOTE
Only S5700EI and S5700HI support the vpn-instance command.
sendpacket passroute command.
NOTE
l If no file path is specified, the system searches for the file in the current path. If the specified file
name does not exist, a file is created according to the specified file name, and the size of the file is
set to 1 MB.
l The file name cannot contain characters such as ~, *, /, \, ', ", but the file path can contain these
characters.
l The file name can contain the extension name but cannot contain the extension name only, such
as .txt.
automatically creates a file name "nqa-ftp-test.txt" to upload.
NOTE
During the FTP test, select a file with a relatively small size. If the file is large, the test may fail because
of timeout.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
267
Advertisement
Table of Contents
