Configuring Parameters For The Pwe3 Ping Test On A Multi-Hop Pw - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Pre-configuration Tasks
Before configuring the PWE3 Ping test on a multi-hop PW, you must correctly configure the
dynamic multi-hop PW or the static multi-hop PW.
Data Preparation
To configure the PWE3 Ping test on a multi-hop PW, you need the following data.
No.
1
2
3
4
5
6
6.20.2 Configuring Parameters for the PWE3 Ping Test on a Multi-
Hop PW
This part describes how to set PWE3 ping test parameters for a multi-hop PW.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type pwe3ping
The test type is set to PWE3 Ping.
Step 4 (Optional) Run:
vc-type ldp
The method of setting up a PW is configured.
Issue 01 (2011-10-26)
Data
ID of the local end of the PW
ID or IP address of the remote end of the PW
Type of the PW
(Optional) Response mode of the Echo packets, LSP EXP, maximum hops, number
of probes, TTL value, and timeout period of the packets
Type and number of the interface connected with the CE
Start mode and end mode of the test
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
310