Example For Configuring The Udp Test - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
l

6.27.9 Example for Configuring the UDP Test

Networking Requirements
As shown in
transmitted between Switch A and Switch C.
Figure 6-11 Networking diagram for configuring the UDP test
SwitchA
Configuration Roadmap
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Issue 01 (2011-10-26)
interface GigabitEthernet0/0/1
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet0/0/2
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet0/0/1
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
nqa-server tcpconnect 10.2.1.2 9000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
Figure 6-11, the NQA UDP Public test is used to obtain RTT of a UDP packet
GE0/0/1 GE0/0/1
VLANIF100 VLANIF100
10.1.1.1/24 10.1.1.2/24
Configure Switch A as the NQA client and configure Switch C as the NQA server.
Configure the monitoring port number on the NQA server and create an NQA UDP Public
test on the NQA client.
Host address of the server
Port number used to monitor the UDP service on the server
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE0/0/2
VLANIF110 VLANIF110
10.2.1.1/24 10.2.1.2/24
6 NQA Configuration
SwitchC
GE0/0/1
NQA Server
351