Huawei Quidway S5700 Series Configuration Manual - Network Management page 98
Hide thumbs
Also See for Quidway S5700 Series:
- Hardware description (253 pages) ,
- Hardware installation and maintenance manual (183 pages) ,
- Quick configuration (74 pages)
Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Procedure
l
l
l
l
Issue 01 (2011-10-26)
Enabling NDP in the system view
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
The system view is displayed.
2.
Run:
ndp enable
By default, NDP is enabled in the system view.
Enabling NDP on an interface
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
The system view is displayed.
2.
Run the following command as required:
– Run:
ndp enable interface { interface-type interface-number [ to interface-
type interface-number ] }&<1-10>
NDP on an interface is enabled in the system view.
– Run:
interface interface-type interface-number
The interface view is displayed.
Run:
ndp enable
NDP is enabled on the interface.
(Optional) Setting the aging time of NDP packets
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
The system view is displayed.
2.
Run:
ndp timer aging aging-time
The aging time of NDP packets is set.
By default, the aging time of NDP packets is set to 180 seconds. The aging time of
NDP packets must be longer than the interval for sending NDP packets.
(Optional) Setting the interval for sending NDP packets
Do as follows on the administrator switch and member switches:
1.
Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
87
Advertisement
Table of Contents
