Example For Configuring Ntp Authentication In Broadcast Mode - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
4.6.3 Example for Configuring NTP Authentication in Broadcast
Mode
Networking Requirements
As shown in
l
l
l
l
l
Figure 4-4 Networking diagram for configuring the NTP broadcast mode
SwitchA
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
Issue 01 (2011-10-26)
port hybrid untagged vlan 100
#
ntp-service unicast-peer 3.0.1.32
#
return
Figure 4-4,
Switch C and Switch D are on the same network segment; Switch A is on another network
segment; Switch F connects the two network segments.
As the NTP broadcast server, Switch C uses the local clock as the NTP master clock, which
is a stratum-3 clock. Switch C sends broadcast packets through VLANIF10, namely,
GigabitEthernet0/0/1.
Switch D uses VLANIF10, namely, GigabitEthernet0/0/1, to listen to the broadcast packets.
Switch A uses VLANIF20, namely, GigabitEthernet0/0/1, to listen to the broadcast packets.
NTP authentication needs to be enabled.
GE0/0/1
VLANIF20 VLANIF20
1.0.1.11/24 1.0.1.2/24
Configure Switch C as the NTP broadcast server.
Configure Switch A and Switch D as the NTP broadcast clients.
Configure NTP authentication on Switch A, Switch C, and Switch D.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE0/0/1
GE0/0/2
VLANIF10
SwitchF
3.0.1.2/24
4 NTP Configuration
GE0/0/1
VLANIF10
3.0.1.31/24
SwitchC
GE0/0/1
VLANIF10
3.0.1.32/24
SwitchD
236