Huawei Quidway S5700 Series Configuration Manual - Network Management page 371

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
Procedure
Step 1 Configure reachable routes between Switch A and Switch B, between Switch A and Switch C,
and between Switch B and Switch C. The configuration details are not mentioned here.
Step 2 Configure LDP on Switch A, Switch B, and Switch C. (The detailed procedure is not mentioned
here.)
For the configuration of LDP, refer to the Quidway S5700 Series Ethernet Switches
Configuration Guide - MPLS.
Step 3 Configure Switch A as the NQA client.
# Enable the NQA client and configure the LDP LSP Ping test.
<SwitchA> system-view
[SwitchA] nqa test-instance admin lspjitter
[SwitchA-nqa-admin-lspjitter] test-type lspjitter
[SwitchA-nqa-admin-lspjitter] lsp-type ipv4
[SwitchA-nqa-admin-lspjitter] destination-address ipv4 3.3.3.9 lsp-masklen 32 lsp-
loopback 127.0.0.1
Step 4 Perform the test.
[SwitchA-nqa-admin-lspjitter] start now
Step 5 Verify the test result.
[SwitchA-nqa-admin-lspjitter] display nqa results test-instance admin lspjitter
----End
Issue 01 (2011-10-26)
Configure Switch A as the NQA client.
Configure Switch C as the NQA server.
Create an LSP Jitter test on Switch A.
Host address and mask of the NQA server
SendProbe:60
Completion :success
Min/Max/Avg/Sum RTT:1/1/1/60
NumOfRTT:60
Operation sequence errors number:0
System busy operation number:0
Min Positive SD:0
Positive SD Number:0
Positive SD Square Sum :0
Max Negative SD:1
Negative SD Sum:1
Packet Loss Unknown:0
jitter out value:0.0162967
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ResponseProbe:60
RTD OverThresholds number:0
RTT Square Sum:60
Drop operation number:0
RTT Stats errors number:0
Operation timeout number:0
Max Positive SD:0
Positive SD Sum:0
Min Negative SD:0
Negative SD Number:1
Negative SD Square Sum :1
Average of Jitter SD:1
6 NQA Configuration
360