Checking The Configuration; Maintaining Lldp - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Context
After the LLDP trap function is enabled, the switch sends traps to the NMS in one of the following
cases:
l
l
l
The LLDP trap function is applied to all interfaces. The LLDP trap function can take effect no
matter whether the LLDP function is enabled globally. If the network topology is unstable,
disable the LLDP function to prevent frequent trap sending.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable feature-name lldptrap
The LLDP trap function is enabled.
By default, the LLDP trap function is disabled on the S5700.
----End

2.3.8 Checking the Configuration

Prerequisite
All configurations are complete.
Procedure
l
l
l
l
----End

2.4 Maintaining LLDP

This section describes how to clear LLDP statistics and monitor LLDP status.
Issue 01 (2011-10-26)
The LLDP function is enabled or disabled globally. The traps are
LLDP_1.3.6.1.4.1.2011.5.25.134.2.1 hwLldpEnabled and
LLDP_1.3.6.1.4.1.2011.5.25.134.2.2 hwLldpDisabled.
The local management address changes. The trap is LLDP_1.3.6.1.4.1.2011.5.25.134.2.5
hwLldpLocManIPAddrChange.
Neighbor information changes. The trap is LLDP_1.0.8802.1.1.2.0.0.1
lldpRemTablesChange. A trap is not generated if the management address of a neighbor
changes.
Run the display lldp local [ interface interface-type interface-number ] command to view
local LLDP status.
Run the display lldp neighbor [ interface interface-type interface-number ] command to
view neighbor information of an interface.
Run the display lldp neighbor brief command to view brief information about neighbors.
Run the display lldp tlv-config command to view the TLV types supported by the interface.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 LLDP Configuration
61