Huawei Quidway S5700 Series Configuration Manual - Network Management page 121

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
Figure 3-3 Networking diagram of configuring basic HGMP functions for a cluster
SwitchA
Device
Administrator-1
Member-2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
Issue 01 (2011-10-26)
NOTE
For convenience, only four devices in the Layer 2 network are described.
test1
GE0/0/1
VLANIF110
10.1.1.1/24
MAC address
0001-0001-0001
0003-0003-0003
Create a management VLAN on all devices. Enable NDP and NTDP to ensure that each
device can detect the topology structure of the network through NTDP.
Choose the administrator switch, and then create a cluster named HUAWEI on the
administrator switch.
Add all the devices that support HGMP in the Layer 2 network to the cluster.
Assign an IP address to VLANIF 10 to facilitate the communication between member
switches in the cluster and devices out of the cluster.
Configure public servers and hosts for the cluster.
Management VLAN ID of the cluster, that is 10
IP address of VLANIF 10, that is 1.0.0.1/8
Address pool of the cluster, that is 10.0.0.0/8
IP address of the administrator in the cluster, that is 10.0.0.1/8
MAC addresses of devices, as shown in
IP addresses of servers and hosts, as shown in
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
SwitchB
GE0/0/1 GE0/0/2
VLANIF110 VLANIF120
10.1.1.2/24
10.2.1.1/24
test2
Figure 3-3
3 HGMP Configuration
SwitchC
GE0/0/1
VLANIF120
10.2.1.2/24
Device MAC address
Member-1 0002-0002-0002
Member-3 0004-0004-0004
Figure 3-3
110