Configuring Http Test Parameters - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
No.
6

6.8.2 Configuring HTTP Test Parameters

This part describes how to set HTTP test parameters.
Context
Do as follows on the NQA client (HTTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test is created and the view is displayed.
Step 3 Run:
test-type http
The test type is set to HTTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the HTTP test
( For detailed parameter configurations, see the chapter
Parameters
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the source port, run the source-port port-numbercommand.
l To configure the destination port, run the destination-port port-number command.
l To configure the percentage of the failed NQA HTTP tests, run the fail-percent percent
l To configure the NQA test packet to be sent without searching the routing table, run the
Step 6 Run:
http-operation { get | post }
Issue 01 (2011-10-26)
Data
Start mode and end mode of the test
):
command.
NOTE
Only S5700EI and S5700HI support the vpn-instance command.
command.
sendpacket passroute command.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
Configuring Universal NQA Test
270