Huawei Quidway S5700 Series Configuration Manual - Network Management page 124
Hide thumbs
Also See for Quidway S5700 Series:
- Hardware description (253 pages) ,
- Hardware installation and maintenance manual (183 pages) ,
- Quick configuration (74 pages)
Table of Contents
Advertisement
Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
# Configure the administrator switch.
[Administrator-1] ntdp enable
[Administrator-1] ntdp timer 10
[Administrator-1] ntdp hop 3
[Administrator-1] interface gigabitethernet 0/0/1
[Administrator-1-GigabitEthernet0/0/1] ntdp enable
[Administrator-1-GigabitEthernet0/0/1] quit
[Administrator-1] interface gigabitethernet 0/0/2
[Administrator-1-GigabitEthernet0/0/2] ntdp enable
[Administrator-1-GigabitEthernet0/0/2] quit
# Configure member switch 1.
[Member-1] ntdp enable
[Member-1] ntdp timer 10
[Member-1] ntdp hop 3
[Member-1] interface gigabitethernet 0/0/1
[Member-1-GigabitEthernet0/0/1] ntdp enable
[Member-1-GigabitEthernet0/0/1] quit
[Member-1] interface gigabitethernet 0/0/2
[Member-1-GigabitEthernet0/0/2] ntdp enable
[Member-1-GigabitEthernet0/0/2] quit
# Configure member switch 2.
[Member-2] ntdp enable
[Member-2] ntdp timer 10
[Member-2] ntdp hop 3
[Member-2] interface gigabitethernet 0/0/1
[Member-2-GigabitEthernet0/0/1] ntdp enable
[Member-2-GigabitEthernet0/0/1] quit
# Configure member switch 3.
[Member-3] ntdp enable
[Member-3] ntdp timer 10
[Member-3] ntdp hop 3
[Member-3] interface gigabitethernet 0/0/1
[Member-3-GigabitEthernet0/0/1] ntdp enable
[Member-3-GigabitEthernet0/0/1] quit
After the previous configuration, globally check the NTDP configuration on the administrator
switch. You can find that the interval and range for NTDP to collect topologies is 10 minutes
and 3 hops respectively.
[Administrator-1] display ntdp
Network topology discovery protocol is enabled
Hops
Timer
Hop Delay : 200 ms
Port Delay: 20 ms
Total time for last collection:0 ms
Step 4 Enable the cluster function and set the management VLAN.
# Configure the administrator switch.
[Administrator-1] cluster enable
[Administrator-1] cluster
[Administrator-1-cluster] mngvlanid 10
[Administrator-1-cluster] quit
# Configure member switch 1.
[Member-1] cluster enable
[Member-1] cluster
[Member-1-cluster] mngvlanid 10
[Member-1-cluster] quit
Issue 01 (2011-10-26)
: 3
: 10 min
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
113
Advertisement
Table of Contents
