Huawei Quidway S5700 Series Configuration Manual - Network Management page 216

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
[HUAWEI_0.Administrator-1] display interface Vlanif 10
Vlanif10 current state : UP
Line protocol current state : UP
Description:HUAWEI, Quidway Series, Vlanif10 Interface
Route Port,The MTU is 1500
Internet Address is 1.0.0.1/8
Internet Address is 10.0.0.1/8 Cluster
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 0001-0001-0001
Step 8 Configure a static route on the administrator switch.
# This operation is to ensure that a reachable route exists between switches in the cluster and
servers or hosts.
[HUAWEI_0.Administrator-1] ip route-static 0.0.0.0 0 1.0.0.2
Step 9 Configure public servers and hosts of the cluster.
# Configure an FTP server.
[HUAWEI_0.Administrator-1] cluster
[HUAWEI_0.Administrator-1-cluster] cluster-ftp-nat enable
[HUAWEI_0.Administrator-1-cluster] ftp-server 2.0.0.1
# Configure a SFTP server.
[HUAWEI_0.Administrator-1-cluster] sftp-server 2.0.0.2
# Configure a Simple Network Management Protocol (SNMP) host.
[HUAWEI_0.Administrator-1-cluster] snmp-host 3.0.0.1
# Configure a log host.
[HUAWEI_0.Administrator-1-cluster] logging-host 4.0.0.1
After the previous configuration, check information about the cluster to which the administrator
switch belongs. You can find that the public log host, SNMP host, FTP server, and SFTP server
are configured successfully.
[HUAWEI_0.Administrator-1-cluster] display cluster
Cluster name:"HUAWEI"
Role:Administrator switch
management vlan id
Cluster multicast MAC address : 0180-c200-000a(default)
Cluster auto-join
Handshake timer:10 sec
Handshake hold-time:60 sec
IP pool:10.0.0.1/8
Logging host:4.0.0.1
SNMP host:3.0.0.1
FTP server:2.0.0.1
SFTP server:2.0.0.2
cluster-member ftp-timeout: 300 sec(default)
Cluster SNMP NAT capability : enabled
Cluster FTP NAT capability : enabled
There are 4 member(s) in the cluster, and 0 of them are down.
Step 10 Disable NDP and NTDP.
# Disable NDP and NTDP on interfaces of all the member switches that do not need NDP and
NTDP.
Issue 01 (2011-10-26)
Input bandwidth utilization
Output bandwidth utilization : --
NOTE
You can also run a routing protocol.
: 10
: disabled
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: --
3 HGMP Configuration
205