Checking The Configuration - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure after how many hops the test is considered failed, run the tracert-
l To configure the initial and the maximum TTL values of the packet, run the tracert-
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
l To perform the NQA test after a certain delay period, run the start delay { seconds second
----End

6.17.3 Checking the Configuration

After configuring the LSP traceroute test, you can view the test result.
Prerequisite
The configurations of the LSP Traceroute Test function are complete.
Context
Procedure
l
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
Issue 01 (2011-10-26)
hopfailtimes timescommand.
livetime first-ttl first-ttl max-ttl max-ttl command.
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } ]
command.
The test instance is started immediately.
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } ] command.
The test instance is started at a specified time.
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } ] command.
The test instance is started after a certain delay.
NOTE
NQA test results cannot be displayed automatically on a terminal. You must run the display nqa results
command to view test results. By the default, the command output contains the records about only the last
five tests.
Run the display nqa results command to view the test results on the NQA client.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 NQA Configuration
301