Adding A Member Switch - Huawei Quidway S5700 Series Configuration Manual - Network Management

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
----End

3.3.5 Adding a Member Switch

To perform unified management over a switch that is not a member of a cluster, you must first
add the switch to the cluster.
Context
After a cluster is set up, you can add a member switch to the cluster either manually or
automatically.
Procedure
l
l
Issue 01 (2011-10-26)
NOTE
The private IP addresses used by a cluster cannot be the same as any IP address on the device.
4. Run:
auto-build [ recover ]
A cluster is created automatically.
The auto-build command can also be used to add member switches automatically.
For configuration details, see
Adding a member switch manually
In this mode, you must manually specify the MAC address of the member switch.
Do as follows only on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
add-member [ member-number ] mac-address mac-address [ password password]
A member switch is added.
Adding a member switch automatically
In this mode, the administrator switch prompts you whether to add all the existing candidate
switches to the cluster. If the authentication mode is used to add member switches, the
administrator switch quits the action of adding a member switch.
Do as follows only on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Adding a Member Switch.
3 HGMP Configuration
92