Huawei Quidway S5700 Series Configuration Manual - Network Management page 131

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure a management VLAN.
# Create VLAN 10 on the device and add interfaces of the administrator switch and member
switches to VLAN 10.
# Configure the administrator switch.
<Quidway> system-view
[Quidway] sysname Administrator-1
[Administrator-1] vlan 10
[Administrator-1-vlan10] quit
[Administrator-1] interface gigabitethernet 0/0/1
[Administrator-1-GigabitEthernet0/0/1] port link-type trunk
[Administrator-1-GigabitEthernet0/0/1] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/1] quit
[Administrator-1] interface gigabitethernet 0/0/2
[Administrator-1-GigabitEthernet0/0/2] port link-type trunk
[Administrator-1-GigabitEthernet0/0/2] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/2] quit
[Administrator-1] interface gigabitethernet 0/0/3
[Administrator-1-GigabitEthernet0/0/3] port link-type trunk
[Administrator-1-GigabitEthernet0/0/3] port trunk allow-pass vlan 10
[Administrator-1-GigabitEthernet0/0/3] quit
[Administrator-1] interface vlanif 10
[Administrator-1-Vlanif10] quit
# Configure member switch 1.
<Quidway> system-view
[Quidway] sysname Member-1
[Member-1] vlan 10
[Member-1-vlan10] quit
[Member-1] interface gigabitethernet 0/0/1
[Member-1-GigabitEthernet0/0/1] port link-type trunk
[Member-1-GigabitEthernet0/0/1] port trunk allow-pass vlan 10
[Member-1-GigabitEthernet0/0/1] quit
[Member-1] interface gigabitethernet 0/0/2
[Member-1-GigabitEthernet0/0/2] port link-type trunk
[Member-1-GigabitEthernet0/0/2] port trunk allow-pass vlan 10
Issue 01 (2011-10-26)
l Run the cluster-ftp command on the member switch to set up a connection with the
public FTP server of the cluster.
For the situation that a device out of the cluster accesses the FTP server (Member-2):
l Calculate the port number reserved on the administrator switch for the FTP protocol of
a certain member switch in the cluster.
l Run the FTP client program on the PC and create an FTP connection with the member
switch.
Management VLAN ID of the cluster, that is 10
IP address of VLANIF 10 that is 1.0.0.1/8 and a reachable route between VLANIF 10 and
the FTP server
Address pool of the cluster, that is 10.0.0.0/8
IP address of the administrator switch used in the cluster, that is 10.0.0.1/8
Member-2 serving as the FTP server in the cluster with the member ID being 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
120