Huawei Quidway S5700 Series Configuration Manual - Network Management page 101

Quidway S5700 Series Ethernet Switches
Configuration Guide - Network Management
l
l
Issue 01 (2011-10-26)
By default, the ID of the management VLAN on the device is 1, which should be
created manually.
– If you do not need to change the default ID of the management VLAN, you can
skip Step 6 and Step 7. The VLAN ID in Step 2 is 1.
– If you need to change the ID of the management VLAN, VLAN IDs in Step 2,
Step 4, and Step 7 must be the same.
3. Run:
quit
The VLAN view is quit.
4. Run:
interface vlanif vlan-id
A VLANIF interface is created and the VLANIF interface view is displayed.
5. Run:
quit
The VLANIF interface view is quit.
6. Run:
cluster
The cluster view is displayed.
7. Run:
mngvlanid vlan-id
A management VLAN is configured.
If you change the ID of the management VLAN or delete the management VLAN and
its corresponding VLANIF interface on the administrator switch, the cluster is
automatically deleted.
If you change the ID of the management VLAN or delete the management VLAN and
its corresponding VLANIF interface on a member switch, the member switch
automatically quits the cluster.
Enabling the cluster function
Do as follows on the administrator switch and member switches:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster enable
The cluster function is enabled.
By default, the cluster function is not enabled on the device.
Creating a cluster
A cluster can be created manually or automatically on the S5700.
NOTE
If the administrator switch is rebooted after the HGMP cluster is created, member switches need to
be re-added into the cluster. In such a situation, numbering of these member switches may be changed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 HGMP Configuration
90