Serial Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter

54.1.6 Serial Parameters

The RS-232 serial parameters are described in the table below.
Parameter
[DisableRS232]
EMS: Baud Rate
[SerialBaudRate]
EMS: Data
[SerialData]
EMS: Parity
[SerialParity]
EMS: Stop
[SerialStop]
EMS: Flow Control
[SerialFlowControl]
Version 6.8
The example above configures user 'v3admin1' with security
level authNoPriv(2), authentication protocol MD5, authentication
text password 'myauthkey', and ReadWriteGroup2.
For a description of this table, see ''Configuring SNMP V3
Users'' on page 79.
Table 54-6: Serial Parameters
Enables the device's RS-232 (serial) port.

[0] = Enabled

[1] = (Default) Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish a
serial communication with the device, refer to the Installation Manual.
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 data bit.

[7] = 7-bit

[8] = (Default) 8-bit
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 polarity.

[0] = (Default) None

[1] = Odd

[2] = Even
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 stop bit.

[1] = (Default) 1-bit (default)

[2] = 2-bit
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 flow control.

[0] = (Default) None

[1] = Hardware
Note: For this parameter to take effect, a device reset is required.
715
54. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway and E-SBC