Axis 2; Changing The Motor Of Axis 2 - ABB IRB 1400 Product Manual

4 Repair

4.3.1 Changing the motor of axis 2

4.3: Axis 2

4.3.1 Changing the motor of axis 2
See foldouts 1 and 5 (6 for IRB 1400H) in the list of spare parts.
The motor and the drive gear constitute one unit.
NOTE!
There are two different types of motors, (Elmo and Yaskawa) The different motors are not
compatible. Make sure to replace with correct model!
To dismantle
Lock the arm system before dismantling the motor; the brake is located in the motor.
1. Remove the cover of the motor.
2. Loosen connectors R3.MP2 and R3.FB2.
3. Remove the connection box by unscrewing <5/160>.
4. Note the position of the motor before removing it.
5. Loosen the motor by unscrewing <1/10>. N.B! The oil will start to run out.
To assemble 1. Check that the assembly surfaces are clean and the motor unscratched.
2. Release the brake, apply 24 V DC to terminals 7 and 8 on the R3.MP2 connector.
3. Install the motor, tighten screws <1/10> to a torque of approximately 2 Nm.
Note the position of the motor!
4. Adjust the motor in relation to the drive in the gearbox.
5. Screw the 3HAB 1201-1 crank tool into the end of the motor shaft.
6. Make sure there is no play.
7. Tighten screws <1/10> to a torque of 8.3 Nm ±10%.
8. Fill with oil. See section Oil in gears 1-4 on page 53.
9. Connect the cabling.
10.Calibrate the robot as specified in section Calibration information on page 131.
Tightening torque
The motor's fixing screws, item10: 8.3 Nm ±10%
72 3HAC021111-001 Revision: B