Table of Contents
Advertisement
2: Installation and commissioning
2.0.1 Transporting and Unpacking
NB!
Before starting to unpack and install the robot, read the safety regulations and other
instructions very carefully. These are found in separate sections in the User's Guide and
Product manual.
The installation shall be made by qualified installation personnel and should conform
to all national and local codes.
When you have unpacked the robot, check that it has not been damaged during trans-
port or while unpacking.
Operating
conditions
Parameter
Ambient temperature
Relative humidity
Storage
If the equipment is not going to be installed straight away, it must be stored in a dry area at
conditions
an ambient temperature between -25°C and +55°C.
When air transport is used, the robot must be located in a pressure-equalized area.
Weight
The net weight of the manipulator is approximately: 225 kg
3HAC021111-001 Revision: B
2 Installation and commissioning
2.0.1 Transporting and Unpacking
Value
+5º to +45º
Max. 95% at constant temperature
31
Advertisement
Table of Contents
