Directions For All Axes - ABB IRB 1400 Product Manual

5 Calibration, M2000

5.2.2 Directions for all axes

5.2.2 Directions for all axes
Calibration When calibrating, the axis must consistently be run towards the calibration position in the
movement
same direction, in order to avoid position errors caused by backlash in gears etc. Positive
directions
directions are shown in the figure below.
This is normally handled by the robot calibration software.
Note! The figure shows an IRB 7600, but the positive direction is the same for all robots!
xx0200000089
104
6+ 4+
3+
2+
1+
3HAC021111-001 Revision: B