Installing The 2U Chassis Fan Assembly - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

Installing the 2U chassis fan assembly

To install the 2U chassis fan assembly, complete the following steps.
1. Touch the static-protective package that contains the fan assembly to any
2. Orient the fan assembly over the opening in the chassis. Make sure that the
3. Lower the fan assembly into the chassis and press down on the tab above the
4. Install the top cover (see "Installing the 2U chassis fan-assembly top cover" on
5. Install the chassis in the iDataPlex rack (see "Installing the 2U chassis in a Type
6. Install any system-board trays that you removed (see "Installing the
134
System x iDataPlex dx360 M2: Problem Determination and Service Guide
Fan assembly
unpainted metal surface on the outside of the chassis; then, remove the fan
assembly from the package.
power connector on the fan assembly aligns with the connector on the power
supply.
power connector to make sure that it is fully seated.
page 135).
7825 iDataPlex rack" on page 187).
system-board tray in a 2U chassis" on page 127).