Installing A Hot-Swap Fan Assembly - IBM System x3350 Type 4192 Problem Determination And Service Manual

Attention:
To remove a hot-swap fan, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Slide the server forward to gain access to the fan doors.
3. Open the fan doors and look for a lit LED near the connector of the failing fan.
4. Press the top of the tab on the cable connector and disconnect the cable of the
5. Pull up on the orange tab to lift the fan out of the server.
6. If you are instructed to return the fan assembly, follow all packaging instructions,

Installing a hot-swap fan assembly

Attention:
To install the replacement hot-swap fan, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
86
IBM System x3350 Type 4192 and 4193: Problem Determination and Service Guide
Table 7. (continued)
Thermal Zone Zone 1
Physical Fan Empty
number
Empty
System Fan Fan set 1
location
To ensure proper server operation, if a fan fails replace it in 48 hours.
on page 57
failing fan from the connector on the system board.
and use any packaging materials for shipping that are supplied to you.
To ensure proper server operation, replace a failed fan within 48 hours.
on page 57
Fan 4 Fan 6 Fan 8
Fan 3 Fan 5 Fan 7
Fan set 2 Fan set 3 Fan set 4
Fan 2
O W O W
F L F L
A IR A IR
Zone 2 Zone 3
Fan 10 Empty
Fan 9 Empty
Fan set 5 Fan set 6
W
L O
R F
A I
Fan 3
Fan 4
Fan 5