Installing The Fan-Bracket Assembly - IBM System x3610 Problem Determination And Service Manual

Installing the fan-bracket assembly

To install the fan-bracket assembly, complete the following steps.
1. Align the fan-bracket assembly with the assembly location on the chassis.
2. Lower the fan-bracket assembly into the chassis.
3. Replace the screws that secure the fan-bracket assembly to the chassis.
4. Install the cover (see "Installing the cover" on page 46).
5. Slide the server into the rack and tighten the rack release thumbscrews.
6. Reconnect the external cables; then, reconnect the power cords and turn on the
7. Check the system-error LED and the fan error LED on the operator information
68
IBM System x3610 Type 7942: Problem Determination and Service Guide
Fan
Fan bracket
peripheral devices and the server.
panel.
Table 10.
Fan error System-error
LED LED
On Any condition
Off On
Meaning
1. The replacement fan-bracket assembly might be faulty;
install a different one.
2. (Trained service technician only) replace the system
board.
Check the LEDs on the system board (see "System-board
LEDs" on page 12). An error LED (amber) that is lit on the
system board or an LED on the hard disk drive backplane
or system board that is off when it should be on can help
isolate the error. See Chapter 5, "Diagnostics," on page 83.