Chapter 1. Start Here; Diagnosing A Problem - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

Hide thumbs Also See for System x iDataPlex dx360 M2:
Table of Contents

Advertisement

Chapter 1. Start here

You can solve many problems without outside assistance by following the
troubleshooting procedures in this Problem Determination and Service Guide and
on the IBM
perform, troubleshooting procedures, and explanations of error messages and error
codes. The documentation that comes with your operating system and software
also contains troubleshooting information.

Diagnosing a problem

Before you contact IBM or an approved warranty service provider, follow these
procedures in the order in which they are presented to diagnose a problem with
your server:
1. Determine what has changed.
2. Collect data.
© Copyright IBM Corp. 2011
®
Web site. This document describes the diagnostic tests that you can
Determine whether any of the following items were added, removed, replaced,
or updated before the problem occurred:
®
v IBM System x
Server Firmware (formerly called BIOS code)
v Device drivers
v Firmware
v Hardware components
v Software
If possible, return the server to the condition it was in before the problem
occurred.
Thorough data collection is necessary for diagnosing hardware and software
problems.
a. Document error codes and system-board LEDs.
v System-board LEDs: See "System-board LEDs and controls" on page 13
for information about system-board LEDs.
v System error codes: See "Event logs" on page 25 for information about
a specific error code.
v Software or operating-system error codes: See the documentation for
the software or operating system for information about a specific error
code. See the manufacturer's Web site for documentation.
b. Collect system data.
Run Dynamic System Analysis (DSA) to collect information about the
hardware, firmware, software, and operating system. Have this information
available when you contact IBM or an approved warranty service provider.
See "Diagnostic programs, messages, and error codes" on page 39 for the
instructions to run the DSA program.
If you need to download the latest version of DSA, go to
http://www.ibm.com/systems/support/supportsite.wss/
docdisplay?brandind=5000008&lndocid=SERV-DSA or complete the
following steps.
Note: Changes are made periodically to the IBM Web site. The actual
procedure might vary slightly from what is described in this
document.
1) Go to http://www.ibm.com/systems/support/.
1

Advertisement

Table of Contents
loading

Table of Contents