Table of Contents
Advertisement
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 123.
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
system-board tray from a 2U chassis" on page 126 or "Removing the
system-board tray from a 3U chassis" on page 128).
3. If a storage enclosure is installed, remove it (see "Removing an expansion
enclosure from a system-board tray" on page 131); otherwise, remove the
system-board tray cover (see "Removing the system-board tray cover" on page
125).
4. Make a note of where cables are attached to the adapter; then, disconnect the
cables.
5. Remove the screw that secures the PCIe riser-card assembly to the
system-board tray and save it for future use.
6. Pinch the two sides of the PCIe riser-card assembly as indicated in above
graphic and pull the PCIe riser-card assembly out of the slot, evenly with both
hands, on the system board.
7. Pull the adapter out of the connector on the PCIe riser-card assembly.
Note: Make sure that the adapter is pulled out carefully. Improper remove of an
adapter might damage the PCIe riser-card assembly or the adapter.
8. If you are instructed to return the adapter, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Chapter 5. Removing and replacing server components
153
Advertisement
Table of Contents
