Removing The 2U Chassis From A Type 7825 Idataplex Rack - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

1. Touch the static-protective package that contains the 2x2 2.5-inch SAS/SATA
2. Place the 2x2 2.5-inch SAS/SATA backplane on the locating pins inside the I/O
3. Install the retaining screws.
4. Reconnect the cables to the 2x2 2.5-inch SAS/SATA backplane.
5. Install the 2.5-inch hot-swap hard disk drives, if you removed any from the I/O
6. Install the I/O enclosure (see "Installing an expansion enclosure on a
7. Install the system-board tray in the chassis (see "Installing the system-board

Removing the 2U chassis from a Type 7825 iDataPlex rack

To remove the 2U chassis from a Type 7825 iDataPlex rack, complete the following
steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
186
System x iDataPlex dx360 M2: Problem Determination and Service Guide
Locating pin
holes
backplane to any unpainted metal surface on the outside of the I/O enclosure;
then, remove the 2x2 2.5-inch SAS/SATA backplane from the package.
enclosure.
enclosure (see "Installing a 2.5-inch hot-swap hard disk drive" on page 140).
system-board tray" on page 132).
tray in a 2U chassis" on page 127).
on page 123.
2x2 2.5-inch hot-swap
SAS/SATA backplane