Table of Contents
Advertisement
Removing a 2x2 2.5-inch SAS/SATA backplane
To remove a 2x2 2.5-inch SAS/SATA backplane from the I/O enclosure, complete
the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Remove the I/O enclosure from the system-board tray (see "Removing an
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Make note of where the drives are installed; then, remove them (see "Removing
6. Make note of where the cables are attached to the backplane; then, disconnect
7. Remove the screws that secure the 2x2 2.5-inch SAS/SATA backplane to the
8. Pull the 2x2 2.5-inch SAS/SATA backplane off the locating pins and out of the
9. If you are instructed to return the 2x2 2.5-inch SAS/SATA backplane, follow all
Installing a 2x2 2.5-inch SAS/SATA backplane
To install a 2x2 2.5-inch SAS/SATA backplane in the I/O enclosure, complete the
following steps.
Locating pin
holes
on page 123.
system-board tray from a 2U chassis" on page 126).
expansion enclosure from a system-board tray" on page 131).
a 2.5-inch hot-swap hard disk drive" on page 139).
Attention:
If the server has an optional RAID adapter and you have installed
or removed a hard disk drive, see the documentation that comes with the RAID
adapter for information about reconfiguring the disk arrays.
them.
I/O enclosure and save them for future use.
I/O enclosure.
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
2x2 2.5-inch hot-swap
SAS/SATA backplane
Chapter 5. Removing and replacing server components
185
Advertisement
Table of Contents
