Installing An I C Multiplexer Card; Removing A Memory Module - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

3. Remove the I/O enclosure from the system-board tray (see "Removing an
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Make a note of where the cables are attached to the I
6. Remove the screws that secure the I
7. Pull the I
8. If you are instructed to return the I
2
Installing an I C multiplexer card
To install an I
1. Touch the static-protective package that contains the I
2. Slide the I
3. Install the retaining screws.
4. Reconnect the cables to the I
5. Install the I/O enclosure (see "Installing an expansion enclosure on a
6. Install the system-board tray in the chassis (see "Installing the system-board

Removing a memory module

To remove a DIMM, complete the following steps.
expansion enclosure from a system-board tray" on page 131).
disconnect them.
and save them for future use.
2
C multiplexer card from the mounting clips and remove the card from
the I/O enclosure.
instructions, and use any packaging materials for shipping that are supplied to
you.
2
C multiplexer card in the I/O enclosure, complete the following steps.
unpainted metal surface on the outside of the I/O enclosure; then, remove the
2
I C multiplexer card from the package.
2
C multiplexer card under the mounting clips.
system-board tray" on page 132).
tray in a 2U chassis" on page 127).
DIMM
Retaining
clip
2
C multiplexer card to the I/O enclosure
2
C multiplexer card, follow all packaging
2
C multiplexer card.
Chapter 5. Removing and replacing server components
2
C multiplexer card; then,
2
C multiplexer card to any
163