Table of Contents
Advertisement
10. If you are instructed to return the hard disk drive backplane, follow all
Installing the 3U chassis hard disk drive backplane
To install the 3U chassis hard disk drive backplane, complete the following steps.
1. Touch the static-protective package that contains the hard disk drive backplane
2. Position the hard disk drive backplane in the 3U chassis and secure it with 10
3. Install the power-supply paddle card and power supply (see "Installing a power
4. Install the system-board tray in the 3U chassis (see "Installing the system-board
5. Install the fan assembly (see "Installing the 3U chassis fan assembly" on page
6. Install the storage-riser-card assembly and ServeRAID SAS controller (see
7. Install the top cover (see"Installing the 3U chassis top cover" on page 137 ).
8. Install the 3U chassis in the iDataPlex rack (see "Installing a 3U chassis in a
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
to any unpainted metal surface on the outside of the 3U chassis; then, remove
the hard disk drive backplane from the package.
screws.
supply in a 3U chassis" on page 176).
tray in a 3U chassis" on page 129).
150).
"Installing a storage-riser-card assembly, ServeRAID SAS controller, and battery
cable interposer card in a 3U chassis" on page 183).
Type 7825 iDataPlex rack" on page 191).
Chapter 5. Removing and replacing server components
189
Advertisement
Table of Contents
