IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 158

Removing a 3.5-inch simple-swap hard disk drive
To remove a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is operating, shut down the operating system; then,
3. Remove the filler panel from the drive bay.
4. Pull the loops of the drive toward each other; then, pull the drive out of the drive
5. If you are instructed to return the hard disk drive, follow all packaging
Installing a 3.5-inch simple-swap hard disk drive
To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
142
System x iDataPlex dx360 M2: Problem Determination and Service Guide
on page 123.
press the power-control button to turn off the system-board tray (see "Turning
off the system-board tray" on page 10 for more information).
bay.
instructions, and use any packaging materials for shipping that are supplied to
you.