Table of Contents
Advertisement
8. If you are instructed to return the hard disk drive bracket and cable assembly,
Installing a four-bay hard disk drive bracket and cable assembly
To install a four-bay hard disk drive bracket and cable assembly in the storage
enclosure, complete the following steps.
Storage
enclosure
1. Touch the static-protective package that contains the hard disk drive bracket
2. Place the hard disk drive bracket and cable assembly on the mounting tabs
3. Reconnect the hard disk drive bracket and cable assembly cables.
4. Install the hard disk drives, if you removed any from the storage enclosure (see
5. Install the storage enclosure (see "Installing an expansion enclosure on a
6. Install the system-board tray in the chassis (see "Installing the system-board
Removing a PCIe riser-card assembly from the system-board tray
To remove a PCIe riser-card assembly from the system-board tray, complete the
following steps.
follow all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
Release latch
and cable assembly to any unpainted metal surface on the outside of the
storage enclosure; then, remove the hard disk drive bracket and cable assembly
from the package.
inside the storage enclosure; then, press down on the hard disk drive bracket
and cable assembly until the release latches click into place.
"Installing a 3.5-inch simple-swap hard disk drive" on page 142).
system-board tray" on page 132).
tray in a 2U chassis" on page 127).
Hard disk drive bracket
and cable assembly
Release latch
Chapter 5. Removing and replacing server components
171
Advertisement
Table of Contents
