Removing The 3U Chassis Top Cover - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

2. Orient the cover over the rear of the chassis so that the retention tabs on the
3. Slide the cover onto the chassis until the cover-release buttons click into place.
4. Install the chassis in the iDataPlex rack (see "Installing the 2U chassis in a Type

Removing the 3U chassis top cover

To remove the 3U chassis top cover, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the chassis is installed in an iDataPlex rack, remove it (see "Removing a 3U
3. Press the two cover-release buttons and slide the cover toward the rear of the
4. If you are instructed to return the 3U chassis top cover, follow all packaging
136
System x iDataPlex dx360 M2: Problem Determination and Service Guide
cover align with the tabs in the chassis.
7825 iDataPlex rack" on page 187).
on page 123.
chassis from a Type 7825 iDataPlex rack" on page 190).
chassis to remove it.
instructions, and use any packaging materials for shipping that are supplied to
you.