Installing An I/O Enclosure Configured With 2.5-Inch Hot-Swap Hard Disk Drives - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

10. Remove the PCIe riser-card assembly (see "Removing a PCIe riser-card
11. If you are instructed to return the I/O enclosure, follow all packaging
Installing an I/O enclosure configured with 2.5-inch hot-swap hard disk
drives
To install an I/O enclosure that is configured with 2.5-inch hot-swap hard disk
drives, complete the following steps.
194
System x iDataPlex dx360 M2: Problem Determination and Service Guide
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 123.
2. If the I/O enclosure is installed on a system-board tray, remove it (see
"Removing an expansion enclosure from a system-board tray" on page 131).
3. Carefully set the I/O enclosure on a flat, static-protective surface.
4. Remove the 2.5-inch simple-swap hard disk drives, if any are installed (see
"Removing and installing a hard disk drive" on page 139).
5. Remove the 2.5-inch SAS/SATA drive cage (see "Removing a 2.5-inch
SAS/SATA drive cage" on page 147).
2
6. Remove the I C multiplexer card (see "Removing an I
page 162).
7. Remove the 2x2 2.5-inch SAS/SATA backplane (see "Removing a 2x2 2.5-inch
SAS/SATA backplane" on page 185).
8. Remove the power-supply paddle card, if one is installed (see "Removing a
power-supply paddle card from an expansion enclosure" on page 178).
9. Remove the PCIe adapters, if any are installed (see "Removing an adapter
from the I/O enclosure" on page 151).
assembly from the I/O enclosure" on page 203).
instructions, and use any packaging materials for shipping that are supplied to
you.
2
C multiplexer card" on