IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 160

I/O enclosure
1. Make sure that no wires are protruding and might interfere with the cover.
2. Orient the PCIe adapter bay cover so that the retention tabs in the cover align
3. Slide the PCIe adapter bay cover into the tab slots in the I/O enclosure.
4. Install the two retaining screws.
5. Install the I/O enclosure on the system-board tray (see "Installing an expansion
6. Install the system-board tray in the chassis (see "Installing the system-board
144
System x iDataPlex dx360 M2: Problem Determination and Service Guide
PCI slots
PCIe bay cover
with the tab slots in the enclosure.
enclosure on a system-board tray" on page 132).
tray in a 2U chassis" on page 127).
Slot cover
Tabs
End of
Bay cover
Adapter
Screws