IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual page 119

Table 3. Integrated management module error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See Chapter 4, "Parts listing," on page 109 to determine which components are customer replaceable
units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Message
The Power Supply %1 has
Failed.
(%1 = CIM_PowerSupply.
ElementName)
The Processor CPU
n Status has a Configuration
Mismatch.
(n = microprocessor number)
The Processor CPU
n Status has Failed with
FRB1/BIST condition.
(n = microprocessor number)
Severity Description
Error
Error A processor configuration mismatch
has occurred.
Error A processor failed - FRB1/BIST
condition has occurred.
Action
(Trained service technician only)
Replace the system board.
1. Make sure that the installed
microprocessors are compatible
with each other (see "Installing
a microprocessor and heat sink"
on page 199 for information
about microprocessor
requirements).
2. (Trained service technician only)
Replace the incompatible
microprocessor.
1. Check for a UEFI firmware
update.
Important: Some cluster
solutions require specific code
levels or coordinated code
updates. If the device is part of
a cluster solution, verify that the
latest level of code is supported
for the cluster solution before
you update the code.
2. Make sure that the installed
microprocessors are compatible
with each other (see "Installing
a microprocessor and heat sink"
on page 199 for information
about microprocessor
requirements).
3. (Trained service technician only)
Reseat microprocessor n.
4. (Trained service technician only)
Replace microprocessor n.
(n = microprocessor number)
Chapter 3. Diagnostics
103