Installing A 2.5-Inch Sas/Sata Drive Cage - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

Installing a 2.5-inch SAS/SATA drive cage

To install a 2.5-inch SAS/SATA drive cage, complete the following steps.
1. Align the 2.5-inch SAS/SATA drive cage with the drive bay; then, carefully slide
2. Connect the power and signal cables to the backplane on the 2.5-inch
3. Install the expansion enclosure, if you removed one (see "Installing an
4. Install the system-board tray in the chassis (see "Installing the system-board
5. Install the hard disk drives, if you removed any (see "Installing a 2.5-inch
148
System x iDataPlex dx360 M2: Problem Determination and Service Guide
the cage into the bay until it stops and the release lever locks into place.
SAS/SATA drive cage.
expansion enclosure on a system-board tray" on page 132); otherwise, install
the system-board tray cover (see "Installing the system-board tray cover" on
page 125).
tray in a 2U chassis" on page 127).
hot-swap hard disk drive" on page 140).