Installing the 2U chassis fan assembly
To install the 2U chassis fan assembly, complete the following steps.
1. Touch the static-protective package that contains the fan assembly to any
2. Orient the fan assembly over the opening in the chassis. Make sure that the
3. Lower the fan assembly into the chassis and press down on the tab above the
4. Install the top cover (see "Installing the 2U chassis top cover" on page 83).
5. Install the chassis in the iDataPlex rack (see "Installing the 2U chassis in a Type
6. Install any system-board trays that you removed (see "Installing the
Fan assembly
unpainted metal surface on the outside of the chassis; then, remove the fan
assembly from the package.
power connector on the fan assembly aligns with the connector on the power
supply.
power connector to make sure that it is fully seated.
7825 iDataPlex rack" on page 124).
system-board tray in a 2U chassis" on page 76).
Chapter 4. Removing and replacing server components
81