Table of Contents
Advertisement
5. Rotate the locking lever on the microprocessor socket from its closed and
6. Use your fingers to pull the microprocessor out of the socket.
7. If you are instructed to return the microprocessor and heat sink, follow all
Installing a microprocessor and heat sink
To install a microprocessor and heat sink, complete the following steps.
Note: The server supports up to two microprocessors. The microprocessors must
Attention:
Do not use any tools or sharp objects to lift the release lever on
the microprocessor socket. Doing so might result in permanent damage to the
system board.
Microprocessor
retainer
locked position until it stops in the fully open position (approximately a 135°
angle). Lift the microprocessor retainer cover upward.
Microprocessor
Microprocessor retainer
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
be the same cache size and type, the same clock speed, and the same size
front-side bus.
Microprocessor
release lever
Alignment marks
Microprocessor
socket
Chapter 5. Removing and replacing server components
199
Advertisement
Table of Contents
