Table of Contents
Advertisement
Removing the system-board tray cover
To remove the system-board tray cover, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Carefully set the system-board tray on a flat, static-protective surface, with the
4. Pull the cover release latch on each side of the system-board tray outward and
5. If you are instructed to return the system-board tray cover, follow all packaging
Installing the system-board tray cover
To install the system-board tray cover, complete the following steps.
Attention:
is installed and closed or an expansion enclosure is installed. Do not attempt to
override this protection.
on page 123.
system-board tray from a 2U chassis" on page 126 or "Removing the
system-board tray from a 3U chassis" on page 128).
cover side up.
lift the cover open.
instructions, and use any packaging materials for shipping that are supplied to
you.
You cannot insert the system-board tray into a chassis until the cover
Chapter 5. Removing and replacing server components
125
Advertisement
Table of Contents
