Removing A Power Supply From A 2U Chassis - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

1. Touch the static-protective package that contains the PCIe riser-card assembly
2. Install the PCIe adapter, if you removed one (see "Installing an adapter in the
3. Press the PCIe riser-card assembly into the riser-card slot on the system board.
4. Install the retaining screw.
5. Install the storage enclosure, if you removed one (see "Installing an expansion
6. Install the system-board tray in the chassis (see "Installing the system-board

Removing a power supply from a 2U chassis

To remove the power supply from a 2U chassis, complete the following steps.
to any unpainted metal surface on the outside of the system-board tray; then,
remove the PCIe riser-card assembly from the package.
system-board tray" on page 154).
enclosure on a system-board tray" on page 132); otherwise, install the
system-board tray cover (see "Installing the system-board tray cover" on page
125).
tray in a 2U chassis" on page 127 or "Installing the system-board tray in a 3U
chassis" on page 129).
Power supply
Power supply
removed
Release
latch
Chapter 5. Removing and replacing server components
173