Removing A 3U Chassis From A Type 7825 Idataplex Rack - IBM System x iDataPlex dx360 M2 Problem Determination And Service Manual

9. Install the hard disk drives (see "Removing and installing a hard disk drive" on

Removing a 3U chassis from a Type 7825 iDataPlex rack

To remove the 3U chassis from a Type 7825 iDataPlex rack, complete the following
steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices (see "Turning off the system-board
3. If external cables are connected to the front of the system-board tray, note
4. Note where the hard disk drives are installed; then, remove them (see
≥ 18 kg (39.7 lb)
5. Remove the screws and slide the 3U chassis from the iDataPlex rack.
6. Set the 3U chassis on a flat, static-protective surface.
7. If you are instructed to return the 3U chassis, follow all packaging instructions,
190
System x iDataPlex dx360 M2: Problem Determination and Service Guide
page 139).
on page 123.
tray" on page 10).
where they are connected; then, remove them.
"Removing and installing a hard disk drive" on page 139).
Statement 4:
CAUTION:
Use safe practices when lifting.
and use any packaging materials for shipping that are supplied to you.
≥ 32 kg (70.5 lb) ≥ 55 kg (121.2 lb)