Table of Contents
Advertisement
6. Install the storage-riser-card assembly and ServeRAID SAS controller (see
7. Install the top cover (see"Installing the 3U chassis top cover" on page 137 ).
8. Install the 3U chassis in the iDataPlex rack (see "Installing a 3U chassis in a
Removing a power-supply paddle card from an expansion enclosure
Note: The following information describes how to remove a power-supply paddle
To remove a power-supply paddle card from an expansion enclosure, complete the
following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Carefully set the system-board tray on a flat, static-protective surface.
4. Remove the expansion enclosure and set it on a flat, static-protective surface
5. If any 3.5-inch simple-swap drives are installed in the expansion enclosure,
6. Make a note of where cables are attached to the power-supply paddle card;
178
System x iDataPlex dx360 M2: Problem Determination and Service Guide
"Installing a storage-riser-card assembly, ServeRAID SAS controller, and battery
cable interposer card in a 3U chassis" on page 183).
Type 7825 iDataPlex rack" on page 191).
card from an I/O enclosure. Removing the power-supply paddle card from
another type of expansion enclosure is similar. A power-supply paddle card is
rarely used in an expansion enclosure.
on page 123.
system-board tray from a 2U chassis" on page 126).
(see "Removing an expansion enclosure from a system-board tray" on page
131).
complete the following steps:
a. Remove the 3.5-inch drives (see "Removing a 3.5-inch simple-swap hard
disk drive" on page 142).
b. Note the cable routing of the hard disk drive bracket and cable assembly
cables; then, disconnect the cables.
c. Remove the hard disk drive bracket and cable assembly (see "Removing
and installing a one-bay or four-bay hard disk drive bracket and cable
assembly" on page 168).
then, disconnect them.
Advertisement
Table of Contents
