Table of Contents
Advertisement
6. If you are installing the hard disk drive bracket and cable assembly in an I/O
7. If you are instructed to return the hard disk drive bracket and cable assembly,
Removing a four-bay hard disk drive bracket and cable assembly
To remove a four-bay hard disk drive bracket and cable assembly from the storage
enclosure, complete the following steps.
Storage
enclosure
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
3. Remove the storage enclosure from the system-board tray (see "Removing an
4. Carefully set the storage enclosure on a flat, static-protective surface.
5. If hard disk drives are installed in the storage enclosure, make note of where
6. Make a note of where the hard disk drive bracket and cable assembly cables
7. Press inward on the hard disk drive bracket and cable assembly release
170
System x iDataPlex dx360 M2: Problem Determination and Service Guide
b. Install the system-board tray in the chassis (see "Installing the system-board
tray in a 2U chassis" on page 127).
enclosure, complete the following steps:
a. Install the I/O enclosure on the system-board tray (see "Installing an
expansion enclosure on a system-board tray" on page 132).
b. Install the system-board tray in the chassis (see "Installing the system-board
tray in a 2U chassis" on page 127).
follow all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
Release latch
on page 123.
system-board tray from a 2U chassis" on page 126).
expansion enclosure from a system-board tray" on page 131).
the drives are installed; then, remove them (see "Removing a 3.5-inch
simple-swap hard disk drive" on page 142).
are attached; then, disconnect them.
latches; then, lift the hard disk drive bracket and cable assembly off the
mounting tabs and out of the storage enclosure.
Hard disk drive bracket
and cable assembly
Release latch
Advertisement
Table of Contents
