Table of Contents
Advertisement
Installing an IBM virtual media key
To install an IBM virtual media key, complete the following steps.
1. Align the virtual media key with the connector.
2. Press on the virtual media key until it is firmly seated in the connector and make
3. Install the expansion enclosure, if you removed one (see "Installing an
4. Install the system-board tray in the chassis (see "Installing the system-board
2
Removing an I
C multiplexer card
To remove a multiplexer card from the I/O enclosure, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. If the system-board tray is installed in a chassis, remove it (see "Removing the
162
System x iDataPlex dx360 M2: Problem Determination and Service Guide
sure that the retention clip engages the virtual media key.
expansion enclosure on a system-board tray" on page 132); otherwise, install
the system-board tray cover (see "Installing the system-board tray cover" on
page 125).
tray in a 2U chassis" on page 127 or "Installing the system-board tray in a 3U
chassis" on page 129).
on page 123.
system-board tray from a 2U chassis" on page 126).
Advertisement
Table of Contents
