Removing The Max5 System-Board Tray - IBM 71455RU Installation And User Manual

Removing the MAX5 system-board tray

To remove the MAX5 system-board tray, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the host server (see "Turning off the server" on page 17) and all
3. Remove the bezel (see "Removing the MAX5 bezel" on page 73).
4. Grasp the blue release latches on the system-board tray handles and press the
5. Grasp the handles and pull the system-board tray out until it stops; then, press
74
IBM System x3850 X5 and x3950 X5 Types 7145 and 7146: Installation and User's Guide
on page 32.
attached peripheral devices. Disconnect all power cords from the MAX5; then,
disconnect all external cables from the MAX5.
release latches in opposite directions and rotate the handles to the fully open
position.
Stop-tab
in the blue stop-tabs on both sides of the system-board tray and pull the tray
out of the chassis.
Alignment
tab
Release
tab
Handle
Release latch
Alignment
tab
Release
tab
Bezel
Stop-tab
Handle
Release latch