Removing The System-Board Tray Cover - IBM iDataPlex dx320 6385 User Manual

Removing the system-board tray cover

To remove the system-board tray cover, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the system-board tray and all attached devices (see "Turning off the
3. If the system-board tray is installed in a chassis, remove it (see "Removing a
4. Carefully set the system-board tray on a flat, static-protective surface, with the
5. Pull the cover release latch on each side of the system-board tray upward; then,
6. Lift the cover off the system-board tray and store it for future use.
Note: If two system-board trays are installed in a 2U chassis, both must have their
covers installed.
20
IBM iDataPlex dx320 User's Guide
System-board
tray cover
on page 17.
system-board tray" on page 15).
system-board tray from a 2U chassis" on page 19).
cover side up.
lift the cover open.
Release
latch
System-board
tray