Removing The System-Board Tray Cover - IBM System x iDataPlex dx360 M3 User Manual

10. Disconnect the battery cable from the battery cable interposer card.
11. Remove the storage-riser-card assembly and ServeRAID SAS controller from
12. Slide and release the retention bracket that secures the fan assembly, and
13. Lift up on both fan-assembly handles and remove the fans from the 3U
14. Note the cable routing and connection locations; then, disconnect the cables
15. Push on the back edge of the system-board tray from inside the 3U chassis
16. Pull the system-board tray out of the 3U chassis and set it on a flat,

Removing the system-board tray cover

Note: If an expansion enclosure is installed on the system-board tray, remove it
instead (see "Removing an expansion enclosure" on page 29).
28
System x iDataPlex dx360 M3: User's Guide
8. Turn the storage-riser-card assembly to access the ServeRAID SAS controller.
9. Pull the controller from the connector on the storage-riser-card assembly.
the 3U chassis.
remove the bracket from the chassis.
chassis.
that connect the system-board tray to the 3U chassis.
and slide the system-board tray forward.
static-protective surface.
System-board
tray cover
Release
latch
System-board
tray